Captiveworks bin files

Wait an additional seconds. Once you see this message power the STB off at the back and hook it up to your TV via your usual setup. After you have the STB hooked up it is time to scan in your channels, pending on your setup whether it be one - two or three LNB's use this guide for your satellite selection.

Echo 6,8 or Echo 8,10 After you have scanned in what ever satellite you require it is time to go to your setup menu and go to system selection and make sure you have all your settings right to move on to the next step. Press system settings and it will lead you to a new menu. Only worry about these settings: a. Hopefully the bin files will get released soon! Thank you for your Patient!

Posted by Spiker at AM 1 comment:. Tuesday, February 5, Dishnetwork viewsat files:. New pansat file:. Posted by Spiker at PM 2 comments:. Coolsat DN fixes. Bev Fixes:. Sunday, February 3, update:. Friday, February 1, Keys:. Newer Posts Older Posts Home. Buy Captive Works Free -to-Air satellite receiver cheap online. We have the best price on CaptiveWork. CaptiveWorks Ultima. Sonicview free to air FTA Files Download is available like other brands such as Coolsat and Captiveworks , all are, free of charge at this site.

Posted on May 20, 0 comments. Everybody knows that there are two types of TV channels. The first one is paid and another is free to use. You will be glad you did this later. MrOkarvi has a How To that contains this information. This Process has been worded to include a more detailed process. Once those files have been properly loaded, you should never have to load them again.

Despite the name, you cannot load software onto the receiver with a USB to serial cable. The first file that you need to load MUST be done using a standard serial port on your computer.

You need to connect the receiver to the computer. Make sure the power is turned off from the front. On the receiver, press and hold the Power button on the front of the receiver while turning the unit on from the rear via the toggle switch. This will be referred to as boot mode Open the V1. The serial port on most computers is usually COM port 1. The software defaults to COM 1 at startup so this should already be selected.

Click the Start Button. NOTE: You should now see a yellow progress bar. Depending upon the settings on your computer and the ammount of resources you have available, this should take between 30 seconds to a couple of minutes.

If your progress bar remains at zero, you will need to stop the transfer and check your settings. The most common problem when using a serial port to transfer data is an improper port setting in the software. Click Start, then Run. Type devmgmt. This will open the Device Manager. This should now show all available ports on the computer. USB cable users need to write down the port number for both the standard serial port and the USB cable.

Change the settings in the loader software to match the port number that you are using and try again. For more help check the Troubleshooting section. Once the transfer finishes, you should see "-End" on the receiver LCD screen and the progress bar on the software will have returned to zero. After the bin has loaded, close the V1. Open the V1. Click the yellow folder icon and locate CX-LoaderV2. Change to the same COM port you just used for V1. Put the receiver into boot mode.

Click the "Start Button" on the loader software.